Harley-Davidson FXDC Super Glide Custom for factory, Chilton & Haynes service repair manuals. Harley-Davidson FXDC Super Glide Custom repair manual PDF.

1. Super Glide Fifth Wheel Hitches

AUTOMATED PDF TO TEXT CONVERTER: 2006 Dyna: Starting & Charging 1-1 HOME CHARGING SYSTEM 1.7 GENERAL 11579 The charging system consists of the alternator and regulator. Charging system circuits are shown in Figure 1-13. Alternator The alternator consists of two main components: ● The rotor which mounts to the engine sprocket shaft. ● The stator which bolts to the engine crankcase. Voltage Regulator See Figure 1-11. The voltage regulator is a series regulator. The circuit combines the functions of rectifying and regulat- ing.

TROUBLESHOOTING Figure 1-11. Voltage Regulator When the charging system fails to charge or does not charge at a satisfactory rate, make the following recommended 11582 checks. Battery Check for a weak or dead battery.

See 1.9 BATTERY TEST for battery testing procedures. Battery must be fully charged in order to perform a load test, or starting or charging tests. However, a partially discharged battery may be tested using the BATTERY TEST function of the MCR-101 HD Electrical System Tester.

Wiring Check for corroded or loose connections in the charging cir- cuit. See Figure 1-13. Voltage Regulator Inspection Figure 1-12. Voltage Regulator Connector 77 Plug at engine crankcase must be clean and tight. Job/Time Code Values Dealership technicians filing warranty claims should use the job/time code values printed in bold text underneath the appropriate repair. 2006 Dyna: Starting & Charging 1-15 HOME SOLENOID PULL-IN TEST b0161a5x Relay terminal Motor terminal 1. See Figure 1-8.

Using a 12 volt battery, connect three separate test leads as follows: a. Solenoid housing to negative battery post.

Solenoid motor terminal to negative battery post. Solenoid relay terminal to positive battery post. Observe starter shaft. If starter shaft extends strongly, solenoid is working properly. If starter shaft does not extend strongly, replace the solenoid. SOLENOID HOLD-IN TEST Figure 1-8.

Test 1: Pull-In Test 1. See Figure 1-9.

Super Glide Fifth Wheel Hitches

Biology florida study guide answer key chapter 11. With test leads still connected in the manner specified in the previous SOLENOID PULL-IN TEST, disconnect solenoid motor terminal/battery b0162a5x negative test lead (B) at negative battery post only; Motor terminal reconnect loose end of this test lead to positive bat- tery post instead. Relay terminal 2. Observe starter shaft. If starter shaft remains extended, solenoid is work- ing properly. If starter shaft retracts, replace the solenoid.

SOLENOID RETURN TEST Battery 1. See Figure 1-10. With test leads still connected in the manner specified at the end of the previous SOLENOID HOLD-IN TEST, disconnect solenoid relay terminal/ positive battery post test lead (C) at either end. Observe starter pinion. Test 2: Hold-In Test a. If starter shaft retracts, solenoid is working properly. If starter shaft does not retract, replace the solenoid.

B0163a5x Motor terminal Relay terminal Battery Figure 1-10. Test 3: Return Test.